Beltronics STiR Plus User Manual Page 15

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 14
26 27
Problem
STiR Plus beeps briefly at the
same location every day, but no
radar source is in sight.
STiR Plus does not seem
sensitive to radar or laser.
STiR Plus did not alert when a
police car was in view.
STiR Plus only beeped twice
during a radar encounter.
STiR Pluss audible alerts are
less loud after the first few
alerts.
STiR Pluss power-on
sequence reoccurs while you
are driving.
Your 14-year old son has
changed all of your Settings.
STiR Plus will not turn on.
Solution
An X or K-band motion sensor or intrusion alarm is
located within range of your route. You can manually
lock this out using TrueLock, or allow AutoLock to do
it over time.
STiR Plus may be in AutoScn or City Nox mode.
VASCAR, (Visual Average Speed Computer And
Recorder) a stopwatch method of speed detection,
may be in use.
This is normal. Full alerts are minimized when
traveling below 20 mph.
STiR Plus is in AutoMute Mode. See page 4 for
details.
A loose power connection can cause STiR Plus to be
briefly disconnected, and will retrigger the power-on
sequence.
You can return all of the Settings to their factory
defaults by holding down the SENS and VOL buttons
while you turn STiR Plus on.
Check that the PWR button is ON.
Check that vehicle ignition is ON.
Check all connections.
Explanation of Displays
Check
Receiver
Wiring
CNX
H
PilotHWY
WorkZone
Caution
Receiver
Error
GPS N/A
Troubleshooting
There is a problem with the front receiver (it could be an unplugged
connection, damaged wiring, or a problem within the front receiver
itself). STiR Plus will continue to display this message, and will not
operate until the problem has been repaired.
Sensitivity control is in City No X-band. (page 7)
Sensitivity control is in Highway mode. (page 14)
One of the many options in Settings (pages 12-16)
One of the many Safety Radar messages (pages 24-25)
STiR Plus has detected a Safety Radar Signal, but the signal isn’t yet
strong enough to decode the specific safety message (pages 24-25)
STiR Plus has failed to calibrate. Contact your Dealer for repair.
Not able to receiver GPS s
ignal. Check GPS antenna connection.
Page view 14
1 ... 14 15 16

Comments to this Manuals

No comments